Printed board: the full 17 x 22 in board with 2 in rounded corners and two 5 x 1 in hand holes, on a 28 x 23 in sheet (have a print shop print it at exact size, ideally on matte Sintra or aluminum). Keep tools inside the dashed gray line, 1/2 in from the edge and the hand holes. The hand holes and corners are added to the cut file for you. The green squares are outside the board; keep all four in the photo and uncovered. Check the 12 in ruler: if it is off, type half of what you measure below.
Print it at 100% / Actual size, not Fit to page, then check that the 6 in ruler along the bottom measures 6 in. Lay the tool inside the four green squares, off the green lines, and photograph straight down in even light. The dotted square marks the top-left, so the sheet can be turned any way in the photo.
Only change this if the ruler is not 6 in. It corrects a printer that scaled the page.
Dark tools on white paper trace best. Shiny, white or pale tools can blend into the paper: use the light box for those.
Photos from your phoneTake the photo on your phone and it shows up here, ready to trace.
Choose the light-box photo or drop it here. JPG or PNG, the whole box in view.
Drag a line across the place where the two tools touch, edge to edge. Press Split again to stop. Numbers change after a split, so split first, then set Square up and the other fixes.
Advanced
Tools are never scaled. The layout is only centered.